Sharp AL-1215 Service Manual page 83

Main Sub
code code
26 06 Destination setup
When this simulation is executed, the current setup of the destination code number is displayed. Enter the code number corresponding
to the destination and press the PRINT switch to enable the setup.
Code number
0
1
2
3
07 Machine conditions check
When this simulation is executed, the current machine setup is displayed.
CPM
10 cpm
12 cpm
13 cpm
14 cpm
15 cpm
20 Rear edge void setup
When this simulation is executed, the current setup of the rear edge void code number is displayed. Enter the code number
corresponding to the rear edge void and press the PRINT switch to enable the setup.
Code number
0
1
30 CE mark support control ON/OFF
When this simulation is executed, the current setup of the CE mark support code number is displayed. Enter the code number
corresponding to the CE mark support setup and press the PRINT switch to enable the setup.
Code number
0
1
The default for CE-support 200V series is "1."
38 Cancel of stop at drum life over
When this simulation is executed, the current setup of the code number is displayed. Enter the code number and press the PRINT
switch to enable the setup.
Code number
0
1
39 Memory capacity check
When this simulation is executed, the current memory capacity is displayed.
Code number
8
16
40 Polygon motor OFF time setup (Time required for turning OFF after completion of printing)
When this simulation is executed, the current setup of the code number is displayed. Enter the code number and press the PRINT
switch to enable the setup.
Code number
0
1
2
3
Destination
Inch series
EX JAPAN AB series
JAPAN AB series
China (EX JAPAN AB series + Chinese paper support)
Copy quantity display
10
12
13
14
15
Rear edge void setup
Rear edge void provided * Default
Rear edge void not provided
CE mark support setup
CE mark support control OFF * Default (100V series)
CE mark support control ON
Setup
Stop at drum life over * Default (AL model)
Cancel of stop at drum life over
Setup
8 Mbyte
16 Mbyte
Setup
0 sec
30 sec * Default
60 sec
90 sec
AL-1551CS SIMULATION, TROUBLE CODES 10 - 6
Content