Sharp AL-1215 Service Manual page 84

Main Sub
code code
26 42 Transfer ON timing control setup
(Operation/Procedure)
1. When this simulation is executed, the currently set code number is displayed.
2. Enter the code number and press the START key, and the setting will be changed. (For any number different from the following
ones, the default time is automatically set.)
Code number
0
1
2
3
4
5
6
7
8
9
43 Side void setup
(Operation/Procedure)
1. When this simulation is executed, the currently set code number of the side void amount is displayed.
2. Enter the code number and press the start key. The setting is changed.
Code number
0
1
2
3
4
5
6
7
8
9
10
44 SPF document rear edge read setup + Fax document rear edge scan setup.
When this simulation is executed, the currently set code number is displayed. Enter the desired code number and press the START
key, and the display will be changed. The document rear edge scanning area in SPF reduction (less than 100%) copy is changed.
The code number is changeable in the range of 0 – 8.
The default value is 4, and 2 mm of the document rear edge is cut.
When the value is changed by 1, the area is changed by 1 mm.
62 Energy-save mode copy lamp setup
Used to set half-ON (50%)/OFF of the copy lamp in the pre-heat mode.
When this simulation is executed, the current setup of the code number is displayed. Enter the code number and press the PRINT
switch to enable the setup.
Code number
0
1
63 Fan control select setup
Used to set the cooling fan operation mode.
When this simulation is executed, the current setup of the code number is displayed. Enter the code number and press the PRINT
switch to enable the setup.
Code number
1
2
Setting
Default (330 msec)
– 40 msec
– 30 msec
– 20 msec
– 10 msec
Default (330 msec)
+10 msec
+20 msec
+30 msec
+40 msec
Setting
0 mm
0.5 mm
1.0 mm
1.5 mm
2.0 mm * Default
2.5 mm
3.0 mm
3.5 mm
4.0 mm
4.5 mm
5.0 mm
Setup
Copy lamp half-ON (50%) * Default
Copy lamp OFF
Setup
1-speed fan control
2-speed fan control * Default when starting mass production
AL-1551CS SIMULATION, TROUBLE CODES 10 - 7
Content