Advertisement
Quick Links
Removing the Chassis Cover
1. Make sure the system and all other peripheral devices connected to it has been
powered-off.
2. Disconnect all power cords and cables.
3. The screw at the rear panel is
used to secure the cover to the
chassis. Remove the cover screw
then put it in a safe place for later
use.
4 Lift the cover by first pulling it
backward (1) then lifting it up (2).
Removing the Drive Bay Bracket
1. The drive bay bracket is readily
accessible when you remove the
cover.
ST101-SR
Installation Guide
(2)
Drive bay
bracket
1/9
Side view
(1)
Advertisement
Related Manuals for DFI ST101-SR
Summary of Contents for DFI ST101-SR
-
Page 1: Installation Guide
ST101-SR Installation Guide Removing the Chassis Cover 1. Make sure the system and all other peripheral devices connected to it has been powered-off. 2. Disconnect all power cords and cables. 3. The screw at the rear panel is used to secure the cover to the chassis. - Page 2 2. The 4 screws are used to secure the drive bay bracket. Remove these screws and put them in a safe place for later use. Top view Side view 3. The drive bay bracket will resemble the one shown on the right.
- Page 3 Installing the SATA and Optical Drives 1. Position the SATA drive at the bottom side of the drive bay bracket. SATA data connector SATA power connector Rear view of the SATA drive 2. To secure SATA to the drive bay bracket, you must fasten screws from the top side of the drive bay bracket.
- Page 4 3. After fastening the screws, on the same side of the bracket (top side), position the optical drive as shown on the right. IDE data connector IDE power connector Rear view of the optical drive 4. Secure the optical drive by fastening screws on each side of the drive bay bracket.
- Page 5 6. The figure on the right shows the locations of the SATA and IDE connectors on the system board. 40-pin IDE SATA connector connector 7. Connect one end of the SATA and IDE data cables to their respective connectors. IDE data cable SATA data cable 8.
- Page 6 9. Connect the other end of the SATA data cable to the SATA drive. Connect the other end of the SATA power cable to the power connector at the rear of the SATA drive. SATA data cable SATA power cable 10.
- Page 7 12. Insert the drive bay bracket from the side of the system. 13. Secure the drive bay bracket by fastening the screws you removed earlier. 14. Replace the chassis cover and secure it with the screw you removed earlier. 15. Insert the provided power cord holder.
- Page 8 Mounting ST101-SR The ST101-SR package includes mounting rails (optional) that can be used for mount- ing the system on the wall. 1. If r ubber feet been previously attached at the bottom of the system, please remove them first. 2. The mounting holes are located at the bottom of the system.
-
Page 9: Package Contents
Package Contents • One ST101 unit • One 120W power adapter (the power cord must be purchased separately according to your area's requirement) • One utility CD • One installation guide • One QR • One 40-pin IDE cable • One ST101 chassis parts kit •...