Select Communications Writing - Omron E5CN Manual

■ Select Communications Writing

● Alarm
Only alarms 1 and 2 are supported.
Alarm 3 cannot be used.
● Heater Burnout Detection
Reads "heater burnout detection 1." (The "heater burnout 2 detection"
value is not read.)
The logic of the MB command changes as shown in the table below
according to the MB command logic switching setting (advanced
function level). The MB command (communications writing selection) is
equivalent to the E5@J Controller's MB command (remote/local
switching).
Text data of MB
command
Communications writing
0000 enabled (remote mode
selection)
Communications writing
0001 disabled (local mode
selection)
• The default value of the MB Command Logic Switching Setting is OFF
(same logic as E5@J).
4.2 Command Descriptions
MB command logic switching setting
OFF
Communications writing
disabled (local mode
selection)
Communications writing
enabled (remote mode
selection)
ON
4-9