General Operation & Programming - Lang ECOF-C Installation And Operation Instructions Manual

General Operation & Programming
Convection ovens constantly circulate air over and around the product. This strips away the thin layer of moisture
and cool air from around the product allowing heat to penetrate more quickly.
Cooking times can be shortened and cooking temperatures can be reduced.
To convert standard deck oven recipes, reduce the temperatrue 50° degrees and the time by 25%. .
Make minor adjustments as necessary.
Always weigh your product. This will give you a more consistent size, color and quality.
Check the product near the end of the initial cooking.
Do not open the oven door during baking, as this will change the baking characteristics of the oven and make it .
difficult to determine a final program.
If the product is overdone on the outside and underdone on the inside, reduce the baking temperature.
If the product is pulling away from the edge of the pan, the temperature is too high or the cooking time too long.
A convection oven is a mechanical piece of equipment. The
same control settings will always give the same results. If
the results vary, problems may be because of changes in the
product preparation.
ECOF-C Control Panel
The Control panel consists of the following items. .
Detailed operational descriptions are given later this .
section.
When open, allows moisture to escape the
Vent Knob:
cooking chamber, allowing a dryer bake. .
(ex: crispy fries)
Turns interior lights on.
Lights:
Turns the oven on and off
Power:
Displays the oven status (preheat, ready,
Status Display:
done) and is the count down timer.
1 : Top Left,
Shelf Timers:
3: Middle Left,
5: Bottom Left,
Labeled C, P, and E these buttons are .
Pace Timers:
adjutable from one to thirty minutes.
There are two "Minute" timers:.
Minute Timers:
"1" is programmed for one minute, .
"2" is programmed for two minutes.
When pressed this button will display the .
Temp Button:
current temperature inside the cooking .
chamber.
Program Enable Buttons:..
Hidden buttons that allow the times of the
shelf position buttons to be set.
Back-Up Controls: These controls give you the basic operation
of the unit, until the primary electonic
controls are operational.
2: Top Right.
4: Middle Right.
6: Bottom Right

Vent Knob
Lights
Power
Status Display
Shelf Timers
Temp Button
Program
Enable Buttons
Back-Up
Controls
LIGHTS
ON
OFF
POWER
ON
OFF
Pace
Timers
Minute
Timers
IL1530