Configuration Examples; Example For Configuring An Ipv6 Address For An Interface - Huawei AR150 series Configuration Manual

Huawei AR150&200 Series Enterprise Routers
Configuration Guide - IP Service
l
l
----End

3.9 Configuration Examples

This section includes the networking requirements, precautions for configuration, and
configuration roadmap. An example is used to describe how to configure an IPv6 address and
Neighbor Discovery Protocol for an interface.

3.9.1 Example for Configuring an IPv6 Address for an Interface

This part provides an example for configuring the IPv6 address of an interface.
Networking Requirement
As shown in
required to configure IPv6 global unicast addresses for the interfaces and test the connectivity
between them.
The IPv6 global unicast addresses to be configured for the interfaces are 3001::1/64 and
3001::2/64.
Figure 3-1 Networking diagram of configuring an IPv6 address for an interface
RouterA
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
Data Preparation
To complement the configuration, you need the following data:
l
Issue 02 (2012-03-30)
Run the reset tcp ipv6 statistics command in the user view to clear all TCP6 statistics after
you confirm it.
Run the reset udp ipv6 statistics command in the user view to clear all UDP6 statistics
after you confirm it.
Figure 3-1, Router A and Router B are connected through GE interfaces. It is
Eth 1/0/0 Eth 1/0/0
3001::1/64 3001::2/64
Enable IPv6 forwarding capability on devices.
Configure IPv6 global unicast addresses for the interfaces.
Global unicast addresses of the interfaces
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
RouterB
3 Basic IPv6 Configuration
76