Configuring Ipv4 And Ipv6 Addresses For The Interface - Huawei AR150 series Configuration Manual

Huawei AR150&200 Series Enterprise Routers
Configuration Guide - IP Service
To enable a device to forward IPv6 packets, you must run this command in the system view;
otherwise, the device cannot forward IPv6 packets although the interface is configured with an
IPv6 address.
By default, the IPv6 packet forwarding capability is disabled.
Step 3 Run:
interface interface-type interface-number
The view of the interface to be enabled with the IPv6 capability is displayed.
Step 4 Run:
ipv6 enable
The IPv6 capability is enabled on the interface.
Before performing IPv6 configurations in the interface view, you must enable the IPv6 capability
in the interface view.
By default, the IPv6 capability is disabled on the interface.
----End

3.5.3 Configuring IPv4 and IPv6 Addresses for the Interface

You need to configure IPv4 and IPv6 addresses separately on the IPv4 and IPv6 networks.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view of the IPv4 network is displayed.
Step 3 Run:
ip address ip-address { mask | mask-length }
An IPv4 address is assigned to the interface.
Step 4 Run:
quit
Return to the system view.
Step 5 Run:
interface interface-type interface-number
The interface view of the IPv6 network is displayed.
Step 6 Perform the following configuration as required.
l Run:
Issue 02 (2012-03-30)
ipv6 address auto link-local
The link-local address is set to be automatically generated.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Basic IPv6 Configuration
68