Configuring Static Neighbors; Enabling Ra Message Advertising - Huawei AR150 series Configuration Manual

Huawei AR150&200 Series Enterprise Routers
Configuration Guide - IP Service
No.
9

3.4.2 Configuring Static Neighbors

By configuring a static neighbor, you can obtain the mapping of the IPv6 address and MAC
address of the neighbor.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
Step 3 Run one of the following commands as required:
l To configure a static neighbor entry on a common Layer 3 interface, run the ipv6
l To configure a static neighbor entry on a VLANIF interface, run the ipv6 neighbor ipv6-
l To configure a static neighbor entry on a sub-interface for QinQ VLAN tag termination, run
Static neighbors can be configured for interfaces and their sub-interfaces. You can configure up
to 300 neighbors on each interface.
----End

3.4.3 Enabling RA Message Advertising

After being enabled with router advertisement, the device can send router advertisement
messages, providing prefixes for hosts.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
Issue 02 (2012-03-30)
Data
Interface MTU
neighbor ipv6-address mac-address command.
address mac-address vid vlan-id interface-type interface-number command.
the ipv6 neighbor ipv6-address mac-address vid vid [ cevid cevid ] command.
NOTE
If an interface is configured with dynamic QinQ, you cannot configure a static neighbor entry on it.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Basic IPv6 Configuration
61