Example For Configuring Layer 2 Topology Detection - Huawei AR150 series Configuration Manual

Huawei AR150&200 Series Enterprise Routers
Configuration Guide - IP Service
<Router> display arp
IP ADDRESS
------------------------------------------------------------------------------
10.10.10.1
10.10.10.2
10.10.10.3
10.10.10.4
10.10.10.5
------------------------------------------------------------------------------
Total:5
----End
Example
The following lists only the configuration file of the Router.
#
sysname Router
#
vlan batch 2 to 4
#
vlan 4
aggregate-vlan
access-vlan 2 to 3
#
interface Vlanif4
ip address 10.10.10.1 255.255.255.0
arp-proxy inter-sub-vlan-proxy enable
#
interface ethernet 0/0/0
port link-type access
port default vlan 2
#
interface ethernet 0/0/1
port link-type access
port default vlan 2
#
interface ethernet 0/0/2
port link-type access
port default vlan 3
#
interface ethernet 0/0/3
port link-type access
port default vlan 3
#
return

1.11.5 Example for Configuring Layer 2 Topology Detection

Networking Requirements
As shown in
view changes of ARP entries, configure Layer 2 topology detection.
Issue 02 (2012-03-30)
MAC ADDRESS
0018-2000-0083
00e0-fc00-0002
00e0-fc00-0003
00e0-fc00-0004
00e0-fc00-0005
Dynamic:4
Figure 1-5, two Ethernet interfaces are added to VLAN 100 in default mode. To
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
EXPIRE(M) TYPE
VLAN/CEVLAN
I -
19 D-0
2/-
19 D-0
2/-
19 D-0
3/-
19 D-0
3/-
Static:0 Interface:1
1 ARP Configuration
INTERFACE VPN-INSTANCE
Vlanif4
Ethernet0/0/0
Ethernet0/0/1
Ethernet0/0/2
Ethernet0/0/3
34