Monitoring The Ip Running Status - Huawei AR150 series Configuration Manual

Huawei AR150&200 Series Enterprise Routers
Configuration Guide - IP Service
Context
The IP/TCP/UDP traffic statistics cannot be restored after being cleared. Exercise caution when
you run the commands.
Procedure
l
l
l
l
----End

7.6.2 Monitoring the IP Running Status

You can monitor the IP running status by running display commands.
Context
In routine maintenance, you can run the following commands in any view to view the IP running
status.
Procedure
l
l
l
l
l
l
l
l
l
Issue 02 (2012-03-30)
CAUTION
Run the reset ip statistics [ interface interface-type interface-number ] command in the
user view to clear the IP traffic statistics.
Run the reset ip socket monitor [ task-id task-id socket-id socket-id ] command in the
user view to clear information in a socket monitor.
Run the reset tcp statistics command in the user view to clear the TCP traffic statistics.
Run the reset udp statistics command in the user view to clear the UDP traffic statistics.
Run the display tcp status [ [ task-id task-id ] [ socket-id socket-id ] | [ local-ip ipv4-
address ] [ local-port local-port-number ] [ remote-ip ipv4-address ] [ remote-port
remote-port-number ] ] command in any view to check the TCP connection status.
Run the display tcp statistics command in any view to check the TCP traffic statistics.
Run the display udp statistics command in any view to check the UDP traffic statistics.
Run the display ip interface [ interface-type interface-number ] command in any view to
check information about an interface.
Run the display ip statistics command in any view to check the IP traffic statistics.
Run the display icmp statistics command in any view to check the ICMP traffic statistics.
Run the display fib acl acl-number [ verbose ] command in any view to check FIB entries
matching the specified ACL.
Run the display fib [ slot-id ] destination-address1 [ destination-mask1 ] [ longer ]
[ verbose ] command in any view to check FIB entries matching the specified destination
address.
Run the display fib [ slot-id ] destination-address1 destination-mask1 destination-
address2 destination-mask2 [ verbose ] command in any view to check FIB entries
matching destination addresses in the range of destination-address1 destination-mask1 to
destination-address2 destination-mask2.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 IP Performance Configuration
188