Configuration Examples; Example For Disabling The Sending Of Icmp Redirection Packets - Huawei AR150 series Configuration Manual

Huawei AR150&200 Series Enterprise Routers
Configuration Guide - IP Service
l
l
l
l
l
l
----End

7.7 Configuration Examples

This section provides IP performance configuration examples.
7.7.1 Example for Disabling the Sending of ICMP Redirection
Packets
Networking Requirements
As shown in
and RouterC are required to be connected with each other by using layer 3 interfaces.
Figure 7-1 Network diagram of Disabling the Sending of ICMP Redirection Packets
Issue 02 (2012-03-30)
Run the display fib ip-prefix prefix-name [ verbose ] command in any view to check FIB
entries matching the specified IP prefix list.
Run the display fib interface interface-type interface-number command in any view to
check FIB entries matching a specified interface.
Run the display fib next-hop ip-address command in any view to check FIB entries
matching a specified next hop address.
Run the display fib [ slot-id ] statistics command in any view to check the total number
of FIB entries.
Run the display fib [ slot-id ] command in any view to check information about the FIB
table.
Run the display ip socket [ monitor ] [ task-id task-id socket-id socket-id | sock-type
socket-type ] command in any view to check the IP socket information.
Figure 7-1, to limit the sending of ICMP redirection packets, RouterA, RouterB,
Eth1/0/0
2.2.2.2/24
RouterC
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
RouterA
Eth1/0/0
1.1.1.1/24
Internet
1.1.1.2/24
7 IP Performance Configuration
Eth1/0/0
RouterB
189