Adjustment After Headlight Assembly Replacement - Hyundai Santa Fe 2002 Owner's Manual

Place vehicle at a distance of 118.1 in. (3m)
from the test wall.
3. See that the vehicle is unloaded (except for
full levels of coolant, engine oil and fuel, and
spare tire, jack, and tools). Have the driver
or equivalent weight placed in driver's seat.
4. Clean the head light lenses and turn on the
headlights (Low beam).
5. Open the hood.
6. Draw the vertical line (through the center of
each headlight beam pattern) and the hori-
zontal line (through the center of each head-
light beam pattern) on the aiming screen.
And then, draw the parallel line at 0.8 in. (21
mm) under the horizontal line.
7. Adjust each cut-off line of the low beam to
the parallel line with a phillips screwdriver -
VERTICAL AIMING
WARNING: WARNING: WARNING:
WARNING: WARNING:
Horizontal aiming should be adjusted by an Horizontal aiming should be adjusted by an
Horizontal aiming should be adjusted by an Horizontal aiming should be adjusted by an Horizontal aiming should be adjusted by an
authorized Hyundai dealer. authorized Hyundai dealer.
authorized Hyundai dealer. authorized Hyundai dealer. authorized Hyundai dealer.
DO-IT-YOURSELF MAINTENANCE DO-IT-YOURSELF MAINTENANCE
DO-IT-YOURSELF MAINTENANCE DO-IT-YOURSELF MAINTENANCE DO-IT-YOURSELF MAINTENANCE
G290B01Y-AAT
Adjustment After Headlight Assembly Adjustment After Headlight Assembly
Adjustment After Headlight Assembly Adjustment After Headlight Assembly Adjustment After Headlight Assembly
Replacement Replacement Replacement
Replacement Replacement
Horizontal line
Cut off
line
H
If the vehicle has had front body repair and the
headlight assembly has been replaced, the
headlight aiming should be checked using the
aiming chart as shown in the illustration. Turn
on the headlight switch. (Low Beam Position)
1. Adjust headlights so that main axis of light is
parallel to center line of the body and is
aligned with point "P" shown in the illustra-
tion.
2. Dotted lines in the illustration show the cen-
ter of headlights.
SPECIFICATION: SPECIFICATION:
SPECIFICATION: SPECIFICATION: SPECIFICATION:
"H";
Horizontal center line of headlights from
ground: 2WD : 32.5 in.(822 mm)
Vertical
line
w
"W";
"P"
Distance between each headlight center:
46.5 in.(1,178 mm)
H
"L";
Distance between the headlights and the
wall that the lights are tested against:
Ground line
118 in. (3,000 mm).
L
G290A03O
4WD : 33.3 in.(843 mm)
6-19