Theft-Alarm System; Armed Stage; Alarm Stage; Disarmed Stage - Hyundai Santa Fe 2002 Owner's Manual

Table of Contents

Advertisement

B070A01S-AAT
THEFT-ALARM SYSTEM (If installed)
This system is designed to provide protection
from unauthorized entry into the car. This
system is operated in three stages : the first is
the "Armed" stage, the second is the "Alarm"
stage, and the third is the "Disarmed" stage.
If triggered, the system provides an audible
alarm.
B070B01O-AAT

Armed Stage

UNLOCK
LOCK
Park the car and stop the engine. Arm the
system as described below.
1) Remove the ignition key from the ignition
switch.
2) Make sure that the engine hood and tail
gate are locked.
3) Lock the doors using the transmitter of the
keyless entry system.
FEATURES OF YOUR HYUNDAI
After completion of the steps above, the turn
signal lamp will blink once to indicate that the
system is armed.
NOTE:
1) If any door, tail gate or engine hood
remains open, the system will not be
armed.
2) If this happens, rearm the system as
described above.
CAUTION:
Do not arm the system until all passengers
have left the car. If the system is armed
while a passenger(s) remains in the car,
the alarm may be activated when the re-
maining passenger(s) leaves the car.
B070C02Y-AAT

Alarm Stage

The alarm will be activated
following occurs while the car is parked and
the system is armed.
B070B01O
1) A front or rear door is opened without using
the transmitter.
2) The tail gate is opened without using the
transmitter.
3) The engine hood is opened.
The siren will sound and the turn signal lamp
will blink continuously for 27 seconds (This
happens 3 times). To turn off the system,
unlock the door or tail gate with the transmitter.
CAUTION:
Avoid trying to start the engine while the
system is armed.
B070D01O-AAT

Disarmed Stage

The system will be disarmed when the driver's
or passenger's door is unlocked by depress-
if any of the
ing the "UNLOCK" button on the transmitter.
After completion of the step above, the turn
signal lamp will blink twice to indicate that the
system is disarmed.
NOTE:
Once the system has been disarmed, it can
not be rearmed except by repeating the
arming procedures.
CAUTION:
Only the transmitter can disarm the armed
stage. If the transmitter does not disarm
B070D01E
1- 5

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents