Table of Contents
Advertisement
the system, it is necessary to take the
following steps;
1. Unlock the door with the key, the alarm
to be activated.
2. Insert the key in the ignition key cylin-
der and turn the ignition key to "ON"
position.
3. Wait for 30 seconds.
After completing the steps above, the sys-
tem will be disarmed.
B070F01A-GAT
Keyless Entry System (If Installed)
Locking doors
1. Close all doors.
2. Push the "LOCK" button on the transmit-
ter.
3. At the same time all doors lock, the turn
signal light will blink once to indicate that
the system is armed.
Unlocking doors
1. Push the "UNLOCK" button on the trans-
mitter.
2. At the same time all doors unlock, the turn
signal light will blink twice to indicate that
the system is disarmed.
1- 6
FEATURES OF YOUR HYUNDAI
B070E02HP-GAT
Replacing the battery
When the transmitter's battery begins to get
weak, it may take several pushes on the
button to lock or unlock the doors, and the
LED will not light. Replace the battery as soon
as possible.
Battery type : CR2032
Replacement instructions:
1. Separate the case with a blade screw-
driver as shown in the illustration.
2. Remove the old battery from the case and
note the polarity. Make sure the polarity of
the new battery is the same(+side facing
down), then insert it in the transmitter.
Screwdriver
B060A02Y-AAT
POWER WINDOWS (If installed)
MSO-0048-1
(1)
Case
Battery
MSO-0048-2
(2)
B060A01O
Hide quick links:
Advertisement
Table of Contents
