Charging The Battery Pack - Sanyo VPC-CG6EX Instruction Manual

CHARGING THE BATTERY PACK

Please charge the supplied battery pack before using it.
1
Insert the battery pack in the
battery charger.
h Insert it in the direction
indicated by the [o] mark
on the battery pack.
2
Connect the supplied power
cord to the socket on the
battery pack charger.
h Insert the connector straight
and securely.
3
Plug the power plug into a
power outlet (AC 100 V to
240 V).
h Recharging begins.
h During recharge, the
CHARGE indicator is lit red.
h The recharge time is
approx. 90 minutes.
4
When the CHARGE indicator
turns off, unplug the power
cord from the power outlet,
and remove the battery pack
from the charger.
HINT
Recharging when connected to the USB terminal (page 9 in the SANYO
Software Pack INSTRUCTION MANUAL)
i The battery can be recharged while the camera is connected to a computer.
i Note, however, that the time it takes to recharge will differ depending on the camera's
operating condition.
i Connect the dedicated USB interface cable to the USB connector on your computer . Do
not connect it to the USB connector on the monitor or the keyboard, or to the USB hub.
i When the surrounding temperature is high, depending on the camera's operating
condition and the battery pack temperature, in some cases the multi-indicator may
slowly flash red and the battery pack cannot be charged.
i If the camera is not going to be used for an extended period of time, please disconnect
the dedicated USB interface cable from the camera.
Downloaded From VideoCamera-Manual.com Manuals
21
English
CHARGE indicator
Battery pack
Socket
To power outlet
Power cord
CHARGE indicator
[o] mark