Radio And Ac Cord Connections; Preparing Remote Control - Panasonic SC-HT743 Operating Instructions Manual

5
STEP
AM loop antenna
≥ Connect the AC power supply cord after all other connections are complete.
≥ Using an outdoor antenna (optional) (➜ page 27).
AM loop antenna
Stand the antenna up on its base.
Place the antenna where reception is best.
Keep loose antenna cable away from other wires
and cables.
AC power
supply cord
To household AC outlet
[For\areas\except\U.S.A.\and\Canada]
≥ If the power plug does not fit your AC
outlet
Use the power plug adaptor (included).
If it still does not fit, contact an electrical
parts distributor for assistance.
Conserving power
The main unit consumes a small amount of power, even when it is turned off (For U.S.A. and Canada: approx. 0.4 W or for other areas: approx.
0.9 W). To save power when the unit is not to be used for a long time, unplug it from the household AC outlet.
You will need to reset some memory items after plugging in the unit.
[Note]
The included AC power supply cord is for use with this unit only. Do not use it with other equipment. Also, do not use cords for other equipment with
this unit.
6
STEP
Remote control
Insert so the poles (i and j) match those in the remote control.
R6/LR6, AA
Replace the cover.
10

Radio and AC cord connections

FM indoor antenna
Main unit
AC IN AC IN
Black
Preparing the remote control
Batteries
Press in and lift up.
≥ Do not use rechargeable
type batteries.
AC power supply cord
\U.S.A.\and\Canada]
[For\areas\except\U.S.A.[and\Canada]
Before connecting the AC
power supply cord
Set the voltage.
110−127V
VOLT ADJ
Use a flat-head screwdriver to move
Click!
the voltage selector to the appropriate
position for the area in which this
system is used.
Loosen the terminal screw with
a Phillips-head screwdriver.
White
Red
While pushing, insert the wire fully.
Do not:
≥ mix old and new batteries.
≥ use different types at the same time.
≥ heat or expose to flame.
≥ take apart or short circuit.
≥ attempt to recharge alkaline or manganese batteries.
≥ use batteries if the covering has been peeled off.
Mishandling of batteries can cause electrolyte leakage which can
severely damage the remote control.
Remove the batteries if the remote control is not going to be used for a
long period of time. Store in a cool, dark place.
∫ Use
Aim at the display (➜ page 11), avoiding obstacles, at a maximum
range of 7 m (23 feet) directly in front of the unit.
Power plug adaptor
\Others]
\Areas\except\U.S.A.\and\Canada]
The illustration shows SC-HT740 for U.S.A. and Canada.
FM indoor antenna
Affix this end of the
antenna where
reception is best.
220−240V Adhesive tape
LOOP
ANT GND
FM ANT
75 75
LOOP
AM
ANT
EXT
Re-tighten the terminal
screw.