Radio And Ac Mains Lead Connections; Preparing The Remote Control - Panasonic SC-HT540 Operating Instructions Manual

5

Radio and AC mains lead connections

STEP
AM loop antenna
≥ Connect the AC mains lead after all other connections are complete.
≥ Using an outdoor antenna (optional) (➜ page 29).
AM loop antenna
Stand the antenna up on its base.
Place the antenna where reception is best.
Keep loose antenna cable away from other wires
and cables.
AC mains lead
[Saudi[Arabia[and[Kuwait[
BE SURE TO READ THE
CAUTION FOR THE AC
MAINS LEAD ON PAGE 4
BEFORE CONNECTION.
To household mains socket
Conserving power
The main unit consumes a small amount of power, even when it is turned off (For Continental Europe: approx. 0.5 W or for other areas: approx.
0.65 W). To save power when the unit is not to be used for a long time, unplug it from the household mains socket.
You will need to reset some memory items after plugging in the unit.
[Note]
The included AC mains lead is for use with this unit only. Do not use it with other equipment. Also, do not use cords for other equipment with this unit.
6

Preparing the remote control

STEP
Remote control
2
Insert so the poles (i and j) match those in the remote control.
3
R6/LR6, AA
12
FM indoor antenna
Click!
Red
Batteries
1
≥ Do not use rechargeable type
batteries.
AC mains lead
[Continental[Europe,[Southeast[Asia,[Thailand,[
[the[Middle[East,[South[Africa,[Saudi[Arabia[and[Kuwait[
FM indoor antenna
Affix this end of the antenna where
reception is best.
Adhesive tape
Main unit
While pushing, insert the wire fully.
White
Loosen the terminal
screw with a Phillips-
head screwdriver.
Black
Do not:
≥ mix old and new batteries.
≥ use different types at the same time.
≥ heat or expose to flame.
≥ take apart or short circuit.
≥ attempt to recharge alkaline or manganese batteries.
≥ use batteries if the covering has been peeled off.
Mishandling of batteries can cause electrolyte leakage which can
severely damage the remote control.
Remove the batteries if the remote control is not going to be used for a
long period of time. Store in a cool, dark place.
∫ Use
Aim at the remote control signal sensor (➜ page 13), avoiding
obstacles, at a maximum range of 7 m directly in front of the unit.
[Saudi[Arabia[and[Kuwait[
The illustration shows the model
for Continental Europe.
[Southeast[Asia,[Thailand,[the[Middle[East,[
[South[Africa,[Saudi[Arabia[and[Kuwait[
Before connecting
the AC mains lead
Set the voltage.
Change the voltage selector to the
appropriate position for the area in
which this system is used.
Re-tighten the
terminal screw.