Radio And Ac Mains Lead Connections; Other Connections - Panasonic SC-RT30 Operating Instructions Manual

Other connections

In the patterns "A"– "D"( page 3–4), you can also connect the main unit and TV with the VIDEO OUT, S VIDEO OUT, and COMPONENT VIDEO OUT
terminals instead of connecting with a fully wired 21-pin Scart cable.
Television's rear panel
COMPONENT
VIDEO IN
Video cable (Included)
Video cables
S Video cable
Included parts to be used
AM loop aerial
1
Connect the aerials.
Push up.
Insert the aerial
cables fully.
White
Black
Red
Loosen the terminal with a
Phillips-head screwdriver.
Tighten the
terminal screw
again.
 The S VIDEO OUT terminal achieves a more vivid picture than the VIDEO OUT terminal. (Actual
results depend on the television.)
VIDEO S VIDEO
IN IN
 COMPONENT VIDEO terminals can be used for either interlace or progressive output (Operations
Guide page 50) and provide a purer picture than the S VIDEO OUT terminal.
 Connect to terminals of the same color.
If you have a regular television (CRT: cathode ray tube)
Use component output with progressive "Off" (Factory setting, Operations Guide 
page 37), even if it is progressive compatible, because progressive output can cause
some fl ickering. This is the same for multi system televisions using PAL mode.
Back of the main unit

Radio and AC mains lead connections

FM indoor aerial
AC mains lead
AM loop aerial
Stand the aerial up on its
base.
Place the aerial where
reception is best.
Keep loose aerial cable away
from other wires and cables.
FM indoor aerial
Affi x this end of
the aerial where
reception is best.
Use FM outdoor
Click!
aerial if radio
reception is poor
(Operations Guide
 page 33).
Back of the
Adhesive tape
main unit
COMPONENT
VIDEO OUT
Main unit
2
Connect the AC mains lead.
AC IN terminal
Back of the main unit
Conserving power
The main unit consumes a small amount of power, even
when it is turned off [approx. 2 W (Power save mode)]. To
save power when the unit is not to be used for a long time,
unplug it from the household mains socket.
Set the unit to standby mode and remove the AC mains
lead after "BYE" disappears from the unit's display.
 You will need to reset some memory items in the unit after
plugging.
Note
The included AC mains lead is for use with this unit only.
Do not use it with other equipment. Also, do not use
cords for other equipment with this unit.
5
CRT
Progressive
COMPONENT
output
VIDEO IN
AC mains lead
To household mains socket
(AC 230 to 240 V, 50 Hz)