T+A PA 2000 R User Manual page 38


Screen
Normal display


Detail display

Screen divisions
Level display
(VU meter)
38
All information relating to the machine's status is displayed on the integral
graphic screen of the PA 2000 R, as is the menu navigation system. The screen
brightness can be adjusted to any of several levels (see chapter entitled 'Basic
settings of the PA 2000 R').
The PA 2000 R features two screen modes.
 Normal display
 Detail display with VU meter - average value display with peak value
You can switch the VU meter on or off in configuration menu.
(see chapter entitled 'Basic settings of the PA 2000 R')
Large-format display of the most important information.
Display with additional superimposed level indicator (VU meter).

The displays and symbols shown on the screen vary according to the source
and settings which are currently active. The screen is divided into the following
areas:
 Display area (a) shows the source name.
 Display area (b) shows the volume level currently set.
 Area (c) shows symbols which indicate the current mode of operation.
(For details refer next page "Screen symbols and their meaning")
 Display area (d) with the level display (VU meter) is only superimposed if the
detail display is selected.

The purpose of the VU meter is to display and monitor the modulation of the
PA 2000 R.
This display is a combination of delayed average display plus the peak value
measured over the last three seconds.