Gamma 7900 Els Owner's Manual page 7

ASSEMBLY INSTRUCTIONS
holes line up and tighten the set screw to lock the threaded insert in place.
Tool Tray Installation
The Tool Tray will be attached to the aluminum
extruded machine base on the right hand
side below the tensioner. To install the tool
tray orient the tray at an angle and carefully
insert the keyed tabs into the horizontal slot
along the top edge of the base.
With the keyed tabs located within the slot in
the machine base slide the tray to the right
edge of the machine and next to the corner
cap of the base. Rotate the tray down until it
is fl ush against the machine base.
Secure the bracket on the rear of the Tool
Tray to the machine base with two hex head
bolts. Align the two holes in the bracket with
the threaded holes in the threaded insert
located in the machine base. Tighten the
bolts with a 6mm hex wrench.
Caution: To prevent damaging the threads
of the inserts in the machine base, do not
overtighten the bolts.
Note: If the holes in the bracke do not line up
with the holes in the threaded insert, loosen
the set screw in the threaded insert and slide
the threaded insert to the left or right until the
7