1000 Mb/S Set Top Check Out Procedure; Maintenance - ADC ADCP-92-052 User Manual

7.2

1000 Mb/s Set Top Check Out Procedure

OptEnet 1000 Mb/s Media Converter modules support Medium Dependent Interface Crossover
(MDI-X). OptEnet Media Converter Module Ethernet ports allow connections to other hubs or
switches without a null-modem or crossover cable. If a null-modem or crossover cable has been
used the OptEnet 1000 Mb/s Media Converter module automatically detects this and switches
the contacts to match the other end.
Set data rate speed to 1000 Mb/s and enable half/full duplex auto-negotiate on any equipment
connected to the OptEnet 1000 Mb/s Media Converter module.
If the Network Interface Card (NIC) or port in the PC workstation has been set to 1000 Mb/s for
speed and duplex, the link LED will be OFF when power is applied unless a valid optical link has
already been established with a remote optical port. If a valid optical link has been established,
link LED will be GREEN for 1000 Mb/s operation. The preferred mode of operation for the NIC
card or port is to select 1000 Mb/s speed and duplex. This insures that a link can be established
regardless of the far end operational mode.

8 MAINTENANCE

Follow standard cleaning practices for maintenance of fiber adapters and connectors.
ADCP-92-052 • Issue 2 • May 2004
Page 13
© 2004, ADC Telecommunications, Inc.