Digital Monitoring Products XR500N Operating Instructions Manual page 37

Using the Panic Zone Test (XR500N/E Only)
1. Access the User Menu.
3. Press any Select key. The keypad displays SYSTEM PANICS.
4. Select PANICS.
5. The Panic Zone Test begins automatically and the keypad
displays TRIPS: END.
by pressing and holding the panic for 1 to 2 seconds.
Note:
mode. The Panic Zone Test takes additional time to display when
the system is in test mode.
minutes.
Note: If testing a key fob, a message will not display if it fails, only
Note:
to the receiver unless pre-programmed at installation to be sent.
Note: Your system may be programmed to limit the Panic Zone Test
to only be performed during the Area 32, Shift 4 schedule.
30
User
authorities and all areas.
not display in the User Menu. When adding User Codes, use the
does not display in the User Menu but when adding User Codes, enter
only have Arm/Disarm assigned to Guest 1 and Guest 2 respectively.
from 1 to 99.
Area Number
the factory. In an XR500 Series system you can assign areas 1 to 32.
In an XR100 Series panel you can assign areas 1 to 8.
Access Area Number
XR500/XR100 User Guide
all
User Menu