Digital Monitoring Products XR500N Operating Instructions Manual page 22

before the system can be armed.
can be bypassed in an area when that area is being armed. This
limit is programmed at installation.
Arming Messages:
For Area systems
For All/Perimeter
For Home/Sleep/Away
For Home/Sleep/Away with Guest systems the main system arms
the same as a Home/Sleep/Away system. A keypad assigned to the
Exit Delay: The keypad then displays the exit delay time as it counts
down. Your system may be pre-programmed at installation to beep
the exit delay tone at eight-second intervals until the last 10 seconds
when the keypad beeps at three-second intervals. After exiting the
building, if you re-enter during the countdown the exit countdown
restarts, allowing additional time to then disarm or again exit the
building during the countdown. This restart can occur only one time.
Arming and Disarming
Note: If your system uses a keyswitch to arm an area, the exit
When you arm both the Perimeter and Interior to leave the
building but then you do not exit by the time the exit delay ends,
may
disarmed because you have not exited.
Should you exit the building and the door does not close properly,
your system may be programmed so that when the exit delay
countdown ends, then the entry delay starts and the bell will sound
to alert you to the situation. Enter your user code to stop the bell
and disarm the system. Rearm the system, exit the building, and
make sure the door is securely closed.
may be programmed to wait for the arming report transmission
to the central station before displaying the armed mes sage. This
the report is received, the keypad displays the armed message. If
before displaying the armed message.
Note: Your system may be pre-programmed at installation to:
XR500/XR100 User Guide
If your system is monitored, it
15