Digital Monitoring Products XR500N Operating Instructions Manual page 19

Arming
Turns on the burglary protection in one or more areas of the
system. When armed, the system is able to sound alarm bells or
sirens and, if monitored, send alarm reports to a central station
Fire, panic, and other 24-hour devices are always turned on and do
not need to be armed.
Central Station Monitoring
Your system can also be programmed to automatically send
alarm, trouble, and arming and disarming reports to a central
Disarming
Turns off one or more areas of the system. When disarmed, the
Fault
that there is a problem with the front door, such as the door being
Zone
12
Instant Zone
Interior protection devices and perimeter devices, such as exterior
tripped while the system is armed, an alarm instantly occurs.
24-hour Zone
Entry or Exit zone
Almost all systems have one or more doors through which you can
access the premises. These doors are programmed with a delay
time to allow you to enter or exit without setting off the alarm.
system is fully armed, opening the door causes the panel to start
the entry delay time. During the entry delay time, you must enter
a valid user code to disarm the system or an alarm occurs.
Status
Status is a feature that automatically displays the armed or dis-
armed status of your system on the keypads. Alarm or trouble
trouble can also display. There are two types of status information
available: Armed Status and Status List.
Status List
The keypad Status List displays any alarm or trouble condition on
The system monitors include the AC power, battery power, panel
box tamper, printer, and phone lines. If more than one alarm or
trouble condition occurs at the same time, the keypad sequences
this information on its display.
XR500/XR100 User Guide Introduction