Hardware Installation - Ubiquiti AF-11G35 Quick Start Manual

Hardware Installation

1. Attach an RF Cable to an RF connector labeled H or V. Then
slide the silicone boot over the RF connector to protect it.
Note:
as determined by your licensing. Keep the other RF
connector covered with the included Metal Cap.
If using MIMO mode, remove the cap over the second RF
connector (V or H) and attach an RF Cable. Then slide the
silicone boot over the RF connector to protect it.
H Connector
2. Attach the airFiber X radio to the antenna by aligning the
four tabs on the back of the radio with the slots of the radio
mount. Then slide the radio down to lock it into place.
For SISO mode, use the RF connector (H or V)
V Connector