Table of Contents
Advertisement
10. Prepare the Azimuth Support Brackets for mounting.
a. Insert the two Small Carriage Bolts into the Azimuth
Support Bracket that has two slotted holes.
b. Slide the slotted hole of the other Azimuth Support
Bracket over one Small Carriage Bolt.
c. Place one Serrated Flange Nut on each Small
Carriage Bolt.
11. Insert the four Bolts with Washers into the four Brackets on
the back of the AF‑11G35 dish and ensure that there is a
13 mm gap between each bolt washer and bracket.
13 mm
13 mm
Advertisement
Table of Contents
