Table of Contents
Advertisement
Antenna Compatibility
The airFiber AF‑11G35 antenna is designed for use with the
airFiber X radio model AF-11FX
Installation Requirements
• 13 mm wrench (pre‑assembly tool)
• 17 mm wrench (pole‑mounting tool)
• airFiber AF-11FX radio (sold separately) with duplexer(s)
installed
• Clear line of sight between airFiber radios
• Vertical mounting orientation
• Mounting point:
• At least 1 m below the highest point on the structure
• For tower installations, at least 3 m below the top of
the tower
• Ground wires – min. 10 AWG (5 mm
As a safety precaution, ground the airFiber radios to
grounded masts, poles, towers, or grounding bars.
WARNING:
airFiber radio will void your warranty.
• (Recommended) 2 Outdoor Gigabit PoE surge protectors
Note:
protection, follow your local electrical regulatory codes.
• (Optional) If not using PoE: DC power source and 12/30 AWG
power cable.
• Outdoor, shielded Category 6 (or above) cabling and
shielded RJ‑45 connectors are required for all wired Ethernet
connections.
* Check your local/regional regulations for the allowable antenna gain
allowed for your application.
Failure to properly ground your
For guidelines about grounding and lightning
.
*
) and max. length: 1 m.
2
Advertisement
Table of Contents
