Introduction Introduction Thank you for purchasing the Ubiquiti Networks airMAX Titanium ™ Sector, model AM-V2G-Ti. This Quick Start Guide is designed to walk you through the installation of the antenna. Package Contents Advanced RF Isolation Variable Beamwidth Antenna Model: AM-V2G-Ti...
Ethernet connections and should be grounded through the AC ground of the PoE. We recommend that you protect your networks from the most brutal environments and devastating ESD attacks with industrial-grade shielded Ethernet cable from Ubiquiti Networks . For more details, visit www.ubnt.com/toughcable ™...
Hardware Installation Hardware Installation 1. Set the desired beamwidth by adjusting the Beamwidth Deflectors. Loosen the four hex head screws enough to move the Beamwidth Deflectors, but do not remove the screws. 2. Carefully move the Beamwidth Deflectors to the desired angle, as indicated by the screw slots.
Page 6
airMAX AM-V2G-Ti Quick Start Guide ™ 4. Attach the RF Cables to the connectors labeled Chain 0 and Chain 1 on the RocketM. 5. Attach the RocketM to the Rocket Mounting Bracket. a. Align the mounting tabs on the back of the RocketM with the four mounting slots on the bracket.
Page 7
Hardware Installation 6. Connect the other ends of the RF Cables to the RF Connectors on the antenna. 7. Slide the Protective Shroud down over the RocketM until it locks onto the Rocket Mounting Bracket. Note: If you have trouble locking the shroud into place, try adjusting the placement of the RF Cables.
Page 8
airMAX AM-V2G-Ti Quick Start Guide ™ 8. Secure the slotted U Bracket to the upper Mounting Lugs of the antenna using two M8 Serrated Flange Nuts. 9. Secure the other U Bracket to the lower Mounting Lugs of the antenna using two M8 Serrated Flange Nuts.
Page 9
Hardware Installation 10. Insert two M8x135 Carriage Bolts into each Pole Bracket. 11. Attach each Pole Bracket to each U Bracket using two M8x20 Serrated Flange Bolts. Hand-tighten only.
Page 10
airMAX AM-V2G-Ti Quick Start Guide ™ 12. To mount the antenna to the pole, slide a Pole Clamp over each pair of M8x135 Carriage Bolts. Secure each Pole Clamp with two M8 Serrated Flange Nuts. Note: The mounting assembly can accommodate a Ø...
Page 11
Hardware Installation 13. The antenna has an electrical downtilt of 4˚. To further adjust the elevation angle, loosen the four M8x20 Serrated Flange Bolts on the U Brackets and the two M8 Serrated Flange Nuts on the upper Pole Clamp. Slide the antenna to the desired tilt. (The brackets may slide along the pole, depending on the angle of the elevation tilt.) Tighten all bolts and nuts to approximately 14 N-m (10 lb-ft) or less to avoid deforming the pole.
Buyer for breach of warranty and shall constitute fulfillment of all liabilities of UBIQUITI NETWORKS with respect to the quality and performance of the Products. UBIQUITI NETWORKS reserves the right to inspect all defective Products (which must be returned by Buyer to UBIQUITI NETWORKS factory freight prepaid).
(IV) All Ethernet cabling runs use CAT5 (or above) shielded cabling. Disclaimer: UBIQUITI NETWORKS does not warrant that the operation of the products is error-free or that operation will be uninterrupted. In no event shall UBIQUITI NETWORKS be responsible for damages or claims of any nature or description relating to system performance, including coverage, buyer’s selection of products for buyer’s application and/or...
Compliance RoHS/WEEE Compliance Statement English European Directive 2002/96/EC requires that the equipment bearing this symbol on the product and/or its packaging must not be disposed of with unsorted municipal waste. The symbol indicates that this product should be disposed of separately from regular household waste streams. It is your responsibility to dispose of this and other electric and electronic equipment via designated collection facilities appointed by the government or local authorities.
Page 16
airMAX AM-V2G-Ti Quick Start Guide ™ Français La directive européenne 2002/96/CE exige que l’équipement sur lequel est apposé ce symbole sur le produit et/ou son emballage ne soit pas jeté avec les autres ordures ménagères. Ce symbole indique que le produit doit être éliminé dans un circuit distinct de celui pour les déchets des ménages. Il est de votre responsabilité de jeter ce matériel ainsi que tout autre matériel électrique ou électronique par les moyens de collecte indiqués par le gouvernement et les pouvoirs publics des collectivités territoriales.
UBIQUITI NETWORKS device, megfelel a vonatkozó alapvetõ [Hungarian] követelményeknek és az 1999/5/EC irányelv egyéb elõírásainak. Íslenska Hér me l sir UBIQUITI NETWORKS yfir ví a UBIQUITI NETWORKS device, er í samræmi vi grunnkröfur og a rar kröfur, sem ger ar eru í [Icelandic] tilskipun 1999/5/EC.
Page 18
AM-V2G-Ti Quick Start Guide ™ Latviski Ar o UBIQUITI NETWORKS deklar , ka UBIQUITI NETWORKS device, atbilst Direkt vas 1999/5/EK b tiskaj m pras b m un citiem ar to saist [Latvian] tajiem noteikumiem. Lietuviškai UBIQUITI NETWORKS deklaruoja, kad šis UBIQUITI NETWORKS įrenginys atitinka esminius reikalavimus ir kitas 1999/5/EB...