Brocade Communications Systems ICX 7450 Hardware Installation Manual page 48

3
Brocade ICX 7450 front panel LEDs
Figure 28
for the 1 GbE ports correspond to the upper, odd-numbered ports; the down-arrow port status LEDs
correspond to the lower, even-numbered ports.
FIGURE 28
The LED definitions for the Brocade ICX 7450-48 are identical to those shown for Brocade ICX
7450-24 (see the table beneath
The Brocade ICX 7450-48P has the following LEDs on the front panel:
•
•
•
•
•
•
•
•
•
38
shows the LEDs on the Brocade ICX 7450-48 front panel. The up-arrow port status LEDs
Brocade ICX 7450-48 front panel LEDs
Two management port monocolor status LEDs (green and amber) for speed and link/activity.
Two power supply unit (PSU) bicolor status LEDs (green and amber) labeled PSU1 and PSU2.
One DIAG (diagnostic) bicolor status LED (green and amber).
One MS (stacking configuration) bicolor status LED (green and amber).
Three MOD (media module) monocolor status LEDs (green).
Ten ID (stack indent if i er) monocolor indicator LEDs (green).
48 1 GbE port bicolor status LEDs (green for 1 GbE and amber for 10/100 Mbps Ethernet)
which indicate 1 GbE or 10/100 Mbps Ethernet mode of operation.
48 PoE+ port monocolor status LEDs (green for providing power to attached device)
10G SFP+ module LEDs:
•
Four 1/10 GbE SFP+ port bicolor status LEDs (green for 10 GbE and amber for 1 GbE)
which indicate 1 GbE or 10 GbE mode of operation.
Figure 26 on page 36).
Brocade ICX 7450 Hardware Installation Guide
53-1003623-02