Assembly
Fig. 5-13:
Unit with base frame
Fig. 5-15:
Screw the base frame to the
connectors
Fig. 5-16:
External view
30
Risk of damage to the unit!
•
Do not attach tensioning belts/hoisting devices to heat exchanger connections,
condensate drains and door handles. Do not use the components to pull or push
the equipment!
•
Before joining the sections for final assembly position them as close to one another
as possible.
•
Use the unit base frame only to pull the sections together.
•
If necessary, underlay round material to simplify pulling the sections together.
•
Use the tensioning belts to pull together units without a base frame. Secure the belts
on the unit profiles at the bottom or roof section.
•
Screw the outer joint connections together.
•
Do not use partition joint connectors to pull the units together.
•
Use screws M8x30.
•
Screw the outer joint connections together.
ATTENTION
max. 100 mm
Fig. 5-14:
Unit without base frame
PR-2009-0096-GB • Subject to modifications • R8-10/2015
CAIRplus