Check And Adjust The Engine Rpm - Genie S-80 Service Manual

Section 3 • Scheduled Maintenance Procedures
CHECKLIST B PROCEDURES
Dual fill port rotator:
2 Remove one of the plugs located on the side of
the hub and check the oil level.
Result: The oil level should be even with the
bottom of the plug hole.
Dual fill port rotator
a motor
b drive hub
c drive hub mounting bolts
d fill ports
3 If necessary, add oil. Refer to Section 2,
Specifications .
4 Apply pipe thread sealant to the plug, and
install the plug in the drive hub.
5 Check the torque of the turntable rotate drive
hub mounting fasteners. Refer to Section 2,
Specifications .
3 - 26
a
b
c
d
S-80 • S-85 • S-80X
B-10
Check and Adjust the
Engine RPM
Maintaining the engine rpm at the proper setting for
both low and high idle is essential to good engine
performance and service life. The machine will not
operate properly if the rpm is incorrect and
continued use may cause component damage.
Continental models:
Note: The engine rpm is controlled by the ECM and
can only be adjusted by re-programming the ECM.
If rpm adjustment or service is required, please
contact the Genie Industries Service Department.
Deutz TD2011L04i models:
1 Connect a tachometer to the engine. Start the
engine from the ground controls and check the
rpm. Refer to Section 2, Specifications.
February 2012
Part No. 122985