Table of Contents
Advertisement
Turning Power On and Off
. Camera-Controller Wireless Connection
The camera and controller communicate over a
Bluetooth wireless technology connection. Once
you perform the "pairing" operation required for
Bluetooth wireless technology connection, the
camera and controller will automatically connect to each other whenever you turn
them on. Note that the connection will be lost when the distance between the camera
and controller becomes too great. The controller will turn off after a preset amount of
time after the Bluetooth wireless technology connection is lost. The camera will
remain on, so you can shoot images by pressing its shutter button.
IMPORTANT!
• Your camera has Bluetooth wireless technology communication functionality built
in. Avoid operating the camera (including camera standalone operations) inside of
aircraft or anywhere else where wireless data communication is restricted.
. To turn on power
Both the camera and controller need to be turned on in order to use them.
Camera
Press [
] (Power).
[
] (Power)
Operation lamp
• Turning on the camera causes the camera and controller operation lamps to light
green, and automatically starts an operation to establish a Bluetooth wireless
technology connection between the camera and controller. An image appears on
the controller and shooting is enabled.
• The connection between the camera and controller is affected by their orientation
and by the distance between them.
• The maximum range for shooting with the controller's shutter button is around
10 meters (32.8'). The maximum range for viewing the image on the controller's
monitor screen is around five meters (16.4').
• If the connection is poor, the controller operation lamp will flash green and
"
" (Communication status between camera and controller) will appear on the
monitor screen. Camera response may be slow if you perform an operation on the
controller while communication conditions are bad. If this happens, try adjusting the
orientation and the distance between the camera and controller.
Controller
Press [
] (Power).
Operation lamp
27
[
] (Power)
Quick Start Basics
Advertisement
Table of Contents
