Table of Contents
Advertisement
. To connect the camera to your computer and save files
1.
On the camera, hold down [
(Power) for about two seconds
to turn off power. Next, use the
micro USB cable that comes
with the camera to connect it
to your computer's USB port.
• For details about connecting to
the camera and precautions
when connecting, see page 24.
2.
Press [
] (Power) to turn on the camera.
When you turn on the camera, check to make sure that the color of its operation
lamp changes from red to green or amber (page 24). Note that in this case the
monitor screen will remain blank.
In this mode, your Macintosh recognizes the memory card loaded in the camera
(or the camera's built-in memory if it does not have a memory card loaded) as a
drive. The appearance of the drive icon depends on the Mac OS version you are
using.
• The first time you connect the camera to your Macintosh with the USB cable,
an error message may appear on your computer. If this happens, disconnect
and then reconnect the USB cable.
3.
Double-click the camera's drive icon.
4.
Drag the "DCIM" folder to the folder to which you want to copy it.
5.
After the copy operation is complete, drag the drive icon to Trash.
6.
Disconnect the camera from the computer.
After the copy or read progress dialog on the computer's screen indicates that the
process is complete, close the displayed image and then disconnect the USB
cable.
]
106
[USB] port
USB
Micro USB cable
(included with camera)
Using the Camera with a Computer
Advertisement
Table of Contents
