Casio EX-FR100 User Manual page 152

Problem
Other
The wrong date and
time are displayed,
or the wrong date
and time are being
stored along with
image data.
The messages on
the display are in
the wrong language.
Images cannot be
transferred over a
USB connection.
Language selection
screen appears
when the camera is
turned on.
There are various
indicators and
values on the
monitor screen.
Buttons are not
responsive right
after the power has
been turned on.
Images are not
displayed.
Possible Cause and Recommended Action
The date and time setting is off. Set the correct date and time
(page 113).
The wrong display language is selected. Change the display
language setting (page 114).
1)The USB cable may not be connected securely to the
camera. Check all connections.
2)If the camera is not turned on, turn it on.
3)Your computer may not be able to recognize the camera if
you connect via a USB hub. Always connect directly to the
computer's USB port.
1)You did not configure initial settings after purchasing the
camera or the camera may have been left with a dead
battery. Check the camera setup (pages 29, 113).
2)There may be a problem with the camera's memory data. If
this is the case, perform the reset operation to initialize the
camera's setup (page 115). After that, configure each
setting. If the language selection screen does not re-appear
when you turn the camera on, it means that the camera's
memory management data has been restored.
If the same message appears after you turn power back on,
contact your retailer or a CASIO authorized service center.
The monitor screen shows indicators and other information
about shooting conditions and the image you are recording.
You can disable display of indicators and values by selecting
"Off" for "Info" on the Setup menu (page 111).
With large capacity memory cards there is a delay after the
power has been turned on before the buttons become
responsive.
1)The camera is turned off.
2)There is no Bluetooth connection between the camera and
controller (page 27).
152
Appendix