Setting Procedures For Printing - Epson Stylus Photo R3000 User Manual

Epson Stylus Photo R3000
Depending on the media type, the print quality may
decline or borderless printing cannot be selected.
"Epson Special Media Table" on page 112
U

Setting Procedures for Printing

Making Settings in Windows[WinOS]
A
When the printer driver's Main[PrnDriver]
screen is displayed, you can configure various
settings required for printing such as Media
Type[PrnDriver], Source[PrnDriver],
Size[PrnDriver].
"Basic Printing Methods (Windows)" on
U
page 30
User's Guide
Printing Varieties
B
Select Borderless[PrnDriver], and then click
Expansion[PrnDriver].
You can not choose the expansion amount when
Roll Paper[PrnDriver] or Roll Paper (Banner)
[PrnDriver] is selected for Source[PrnDriver].
C
Select Auto Expand[PrnDriver] or Retain
Size[PrnDriver] as the Method of
Enlargement[PrnDriver]. If you select Auto
Expand[PrnDriver], set how much of the image
goes beyond the edge of the paper as shown
below.
Max[PrnDri
ver]
Mid[PrnDriv
er]
Min[PrnDriv
er]
61
Sizes larger than A4:
Approximately 3 mm past the top,
4.5 mm past the bottom, and 3.5 mm
past the left and right edges
A4 or smaller (excluding 100 × 148
mm, 9 × 13 cm/3.5 × 5 in., 10 × 15
cm/4 × 6 in.):
Approximately 3 mm past the top, 4
mm past the bottom, and 2.5 mm
past the left and right edges
100 × 148 mm, 9 × 13 cm/3.5 × 5 in.,
10 × 15 cm/4 × 6 in.:
Approximately 1.3 mm past the top,
2.5 mm past the bottom, and 2.5 mm
past the left and right edges
½ of Max
¼ of Max