Siemens simatic ET 200SP User Manual page 45

Using a programming device/PC to install the license keys
The
and the CPU 1515SP PC.
1. Connect the CPU 1515SP PC to a programming device/PC.
2. Connect the supplied USB stick to the programming device/PC.
3. Select the menu command Start > SIMATIC > License Management > Automation
License Manager.
4. Select the Edit > Connect Computer menu command and type in the IP address of the
CPU 1515SP PC (default 192.168.1.1).
5. Drag the license keys from the USB stick to the system partition C: of the CPU 1515SP
PC.
Saving and securing license keys in the case of restore and repair
Note
Loss of license keys
A SIMATIC license key cannot be copied or duplicated. No more license key copies exist on
the USB stick once you have dragged the license keys from the USB stick to the
CPU 1515SP PC.
Secure your purchased license keys before restoring the delivery state (Restore) or in the
case of repair. To do this, move the license keys to a USB stick and keep this stick in a safe
place.
If an error occurs on your license keys on the CPU 1515SP PC, contact your Siemens
representative. Make sure to have the "Certificate of License" (CoL) to hand.
Note
The EWF (Page 67) write filter serves to protect your license keys and your configuration.
Reference
For additional information on licenses, refer to the
This can be found on the CPU 1515SP PC under Start > All Programs > Siemens
Automation > Documentation and on the Internet
(http://support.automation.siemens.com/WW/view/fr/56956174).
CPU 1515SP PC
Manual, 12/2014, A5E32701806-AA
Automation License Manager
is pre-installed on a programming device/PC with STEP 7
Automation License Manager
Commissioning
7.3 Installing license keys
manual.
45