Procomp B683 User Manual page 45

B683/B680
3. Once the above two steps have been completed, slot the CPU Retention
into Slot1. Pull up the CPU stays on both side of the CPU Retention so
they are horizontal, at an angle of 90°. Then the side of the CPU
Retention with no mark on it and the side of Slot1 with the small
rectangular tab should be on the same side.
!
The CPU Retention has to
go in a particular direction.
Make sure that it is the right way
round before slotting it in. Do
not force it in, otherwise you may
damage the motherboard and
CPU Retention.
4. Ensure that the CPU Retention has been slotted all the way in, then screw
the four plastic screws into the sockets on each side of Slot1 to make sure
that the CPU Retention is fixed firmly in position.
42