Giant CONTACT SL SWITCH User Manual page 10

Thread cable to the cable
hole.
III. Adjust remote cable
CAUTION: Add a cable end to the remote cable to prevent the cable from
having a sharp end or to keep it from fraying.
IV. Assemble the seatpost to bike.
Insert the seatpost into seat tube with a minimum of 100mm

insertion, and then tighten the seatpost clamp according to the
bicycle manufacturer's recommendations.
Loosen the clamp bolt of saddle clamp unit, put the saddle rail on the

lower rail support, adjust saddle position, and then fasten the clamp
bolt.
Sit on the saddle and adjust seatpost height to ensure proper

functionality before riding.
WARNING: Do not ride if the seatpost height-adjusting functionality
operates improperly.
Mount the control unit to the handlebar and fasten within
3mm hex key.
Recommended Torque: 1.6Nm | 14 lbs-in | 16 kgf-cm
Adjust the cable so the cable casing, barrel and remote
unit are tightly connected so the control lever is properly
positioned and the cartridge moves properly. Fasten the
screw using a 2mm hex key.
The recommended torque: 1.2Nm | 10 lbs-in | 12kgf-cm
Cut the excess cable.
9