Procedures; Disassembling & Reassembling Cartridge - Giant CONTACT SL SWITCH User Manual



PROCEDURES

DISASSEMBLING & REASSEMBLING CARTRIDGE
Disassembling The Cartridge
Cartridge fixing screws
Remove the lower cap
using a 8mm hex key.
Reassembling The Cartridge
Attach the cartridge to the
lower cap. Fasten the
cartridge screws to the
recommended torque.
Re
Remove the cartridge fixing
screws from saddle clamp
body using a 2.5 mm hex
key. Pull out the cartridge.
Operate the trigger to compress the cartridge through
about half it's travel (approximately 50mm) to make
installation of the cap easier and allow the cartridge to
function properly once installed.
6
Remove screws from the
lower cap. Remove the
lower cap from cartridge.