Introduction; Self-Test - Keysight u2722a Service Manual

2 Getting Started

Introduction

Self-Test

C A U T I O N
10
• A brief power-on self-test occurs automatically whenever
you turn on the instrument. This limited test assures that
the instrument is capable of operation.
• If the self-test fails, the power indicator on the front
panel will start blinking. You can use the SYSTem:ERRor?
query command from the remote interface to read the
error messages. If repair is required, contact a Keysight
Service Center. Please refer to the programmer's reference
guide for more information on the error messages.
• Self-test may be initiated remotely by sending the *TST?
SCPI command to the instrument.
Disconnect all connections from the output terminals before
performing the self-test procedure. Ensure that the output terminals
are not connected to any load before you turn on the U2722A/U2723A.
Keysight Measurement Manager
To start the self- test procedure using the Keysight
Measurement Manager, perform the following steps.
1 Click Tools > Self-Test.
U2722A/U2723A Service Guide