Taking Pictures Using Burst Mode - Panasonic LUMIX DMC-GF1K Operating Instructions Manual

Advanced (Recording pictures)
[REC] mode:

Taking Pictures using Burst Mode

Pictures are taken continuously while the shutter button is pressed.
Select the ones you really like from among the pictures you have taken.
Set the drive mode lever to [
Focus on the subject and take a picture.
A When Burst Mode is set to high speed [H].
• Hold down the shutter button fully to activate the
burst mode.
∫ Changing the burst speed
1
Select [BURST RATE] in the [REC] mode menu. (P28)
2
Press 3/4 to select the burst speed and then press
[MENU/SET].
3
Press [MENU/SET] to close the menu.
• You can also press the shutter button halfway to close the menu.
Burst speed (pictures/second)
With RAW files
¢
1
Without RAW files
¢1 Number of recordable pictures
¢2 Pictures can be taken until the capacity of the card becomes full. However the burst speed
will become slower halfway. The exact timing of this depends on the aspect ratio, the picture
size, the setting for the quality and the type of card used.
• First burst speed has no relation with the transfer speed of the card.
• The burst speed values given above apply when the shutter speed is 1/60 or faster and when
the flash is not activated.
• The Burst Mode speed may become slower depending on the following settings.
– [SENSITIVITY] (P80)/[PICTURE SIZE] (P117)/[QUALITY] (P118)/[FOCUS PRIORITY]
(P129)/Focus mode
• Refer to P118 for information about RAW files.
66
VQT2G62
].
[H] (High speed)
3
Depends on the remaining capacity of the card
A
[L] (Low speed)
2
¢2
4 to 7
¢2