Table of Contents
Advertisement
RUGGEDCOM RX1000
Installation Guide
The following sections describe each component in the GPS antenna system in more detail:
•
Section 3.7.3.1, "GPS Antenna"
•
Section 3.7.3.2, "Antenna Cabling"
•
Section 3.7.3.3, "Lightning Considerations"
•
Section 3.7.3.4, "Line Amplification and Filtering"
Section 3.7.3.1
GPS Antenna
There are two major types of GPS antenna: passive and active. A passive antenna requires no power and is
an option when signal strength is not a concern. An active antenna has a built in Low Noise Amplifier (LNA)
to increase the strength of the signal, and to compensate for the signal loss in a long cable connection. Active
antennas are used when the antenna input is connected to the receiver through a coaxial cable (usually longer
than 3 m) or any high loss transmission path.
NOTE
• The PTP card's GPS input provides 5 VDC at up to 10 mA to power the antenna.
• Best results can be achieved with a total gain of 16 dB (includes antenna gain, cable loss, lightning
arrestor loss, line amplifier gain and filter loss) at the antenna input.
The PTP Card requires an active antenna with the following specifications:
Total Gain at PTP GPS Input (includes antenna gain, cable
loss, lightning arrestor loss, line amplifier gain and filter loss)
Section 3.7.3.2
Antenna Cabling
Cable Impedance: Siemens recommends low loss 50 Ω coaxial cabling.
Cable Delay: Using any length of coaxial cable will add some time delay to the GPS signal which degrades
the accuracy of the calculated time and position. The time delay is dependent on the type of dielectric material
in the cable and ranges from 1 to 2 ns/ft. Siemens provides a method to account for this delay through the
web management interface by entering the time delay into the cable compensation box under PTP General
Configuration. The table below gives some examples of the delay that can be expected based on the dielectric
type.
GPS Antenna
Characteristic
Polarization
Receive Frequency
Power Supply
DC Current
Antenna Gain
Axial Ratio
Output VSWR
Active Antenna
Right-Hand Circular Polarized
1.57542 GHz ± 1.023 MHz
5 VDC
< 10 mA at 3 VDC
Select antenna gain based on system configuration
Total Gain ≤ 18 dBi
< 3 dB
< 2.5
Chapter 3
Communication Ports
25
Advertisement
Table of Contents
