Installing A Gps Antenna - Siemens RUGGEDCOM RSG2288 Installation Manual

RUGGEDCOM RSG2288
Installation Guide
Figure 13: Dual AC/DC Power Supply
Section 2.3

Installing a GPS Antenna

For increased signal coverage and improved performance, the GPS antenna is intended to be installed in a
remote location separate from the RUGGEDCOM RSG2288.
IMPORTANT!
A PTP card must be installed in the RUGGEDCOM RSG2288 for GPS capabilities. For more
information, refer to
NOTE
A specific brand of antenna is not specified.
To install the GPS antenna, do the following:
IMPORTANT!
The antenna installation must be as per Article 810 of the NEC. Specifically, the grounding conductor
must not be less than 10 AWG (Cu). The scheme should be either:
• In accordance with UL 96 and 96A Lightning Protection Components and Installation Requirements
for Lightning Protection Systems (LPS)
• Tested in accordance with UL 50 and UL 497
IMPORTANT!
A Radio Frequency (RF) site survey is recommended prior to any installation to help determine the
best location for the GPS antenna. For assistance, contact a Siemens Sales representative.
Installing a GPS Antenna
Section 1.3, "Precision Time Protocol (PTP) Support".
Chapter 2
Installing Device
17