Receiver's Front And Rear Panels; Osd Menu - Hall Research Technologies HHD264 User Manual

Hdmi distribution and switching over lan with rs-232 & ir extension dynamic virtual matrix

Hide thumbs Also See for HHD264:

Table of Contents

4.3 Receiver's Front and Rear Panels

The functions of the connectors on the Receiver are similar to those of the

Sender described in the previous section.

Once the installation is completed, the following On Screen Display (OSD) is

displayed on the screen. The OSD behavior can be controlled using Hall

Research's Dynamic Virtual Matrix Tool™

command. The user can conveniently select Auto, ON, OFF options. Auto allows

the OSD to be displayed for 10 seconds, while the user can select the ON and

OFF feature to enable or disable the OSD.

F/W Ver:

The firmware version.

RX IP:

This receiver's IP address.

TX IP:

The connected transmitter's IP address. Note that the transmitter and

GROUP ID:

This receiver's group number.

the receiver must be in the same group else 0.0.0.0 will be displayed.

DEVICE ID:

STATUS:

Shows the link status. If no transmitter is found in the receiver's

This receiver's device name (user assignable).

group "Waiting for connection..." will be displayed.

If the TX and RX are in the same group, but no HDMI source connected to the TX,

then the message "Stream Not Found!" will be displayed.

Figure 4.4 - Receiver's Front Panel

Figure 4.5. Receiver's Rear Panel

Figure 5.1 - OSD

Dynamic Virtual Matrix™

Windows Software

or Telnet

Table of Contents