H3C S3610 Series Quick Start Manual page 69

Quick Start
H3C S3610 Series Ethernet Switches
(1) (1) (1) (1)
(1): Power input on the switch
(3): ground wire
Figure 3-14 Grounding the switch through a grounding strip
When there is no grounding strip but earth near the
equipment room that allows a grounding body to be buried,
hammer an angle iron/steel pipe longer than 0.5 m into the
earth, weld the yellow-green ground wire of the switch onto
the angle iron/steel pipe, and process the joint against
erosion.
Chapter 3 Installing the Switch
(2) (2)
(2): Grounding screw on the switch
(4): Grounding strip
3-16
(3) (3)
(4) (4) (4) (4)