H3C S3610 Series Quick Start Manual page 65

Hide thumbs Also See for S3610 Series:

Table of Contents

Quick Start

H3C S3610 Series Ethernet Switches

Connect one end of the grounding cable (delivered with the

switch) to the grounding screw and the other end to the

ground nearby.

Connect the 12V-RPS DC power supply as follows:

Step1: As shown in Figure 3-11, loosen the fastening screws and

remove the air filter from the 12V-RPS DC power socket. (In the case

of no 12V-RPS DC power supply, re-install the air filter.)

(1): Air filter

Figure 3-11 12V-RPS power socket for an

S3610-52M/S3610-52M-DC Ethernet switch

Step2: Connect one connector of the 12V-RPS DC power cable

to the RPS DC power socket of the switch, and the other connector to

the corresponding 12 V power output socket of the RPS power

module.

Step3:Connect one end of the delivered AC power cable to the

power socket of the RPS power module and the other end to the

socket of an external AC power supply.

Check whether the PWR LED on the front panel of the

switch is ON. If yes, the power is properly connected.

Chapter 3 Installing the Switch

(1)

(2)

(2): Fastening screw

3-12

Table of Contents