H3C S3610 Series Quick Start Manual page 59

Quick Start
H3C S3610 Series Ethernet Switches
V. Use front mounting ears and guide rails
Follow these steps to install a switch into a 19-inch standard
cabinet:
1) Wear an ESD-preventive wrist strap to check the grounding
and stability of the cabinet.
2) Take out the screws packed together with the front mounting
ears and fix one end of the front mounting ears to the switch,
as shown in Figure 3-3.
3) Install guide rails on the brackets on both sides of the
cabinet with M5 self-tapping screws. Figure 3-5 is for
reference only.
Figure 3-5 Install guide rails
4) Hold the two sides of the switch and slide it gently along the
guide rails into the cabinet until it is located in a proper
position, as shown in Figure 3-6. Ensure that the bottom side
of the guide rails and the switch are in close contact.
Chapter 3 Installing the Switch
3-6