H3C S3610 Series Quick Start Manual page 62

Quick Start
H3C S3610 Series Ethernet Switches
II. Connecting the AC Power Cord
Step 1: Connect one end of the chassis ground wire to the
grounding screw on the rear of the chassis and the other end to the
ground as near as possible.
Step 2: Connect one end of the power cord to the power input on
the rear panel of the chassis, and plug the other end to the AC power
input of the power source.
Step 3: Check whether the PWR LED on the front panel of the
switch is ON. If the LED is ON, it shows the power cord is properly
connected.
Caution:
Make sure that the ground wire has been properly connected before
powering on the switch.
Chapter 3 Installing the Switch
3-9