Quick Start
H3C S3610 Series Ethernet Switches
Screw 2
Screw 2
Figure 3-13 Fix RPS connector to the cabinet
Step 2: Directly insert the component into DC-input socket on the
cabinet, and then fix the screws 1 and 2 carried by the connector itself
to the appropriate holes on the cabinet socket using a small flathead
screwdriver, see Figure 3-13.
Step 3: Check that the RPS LED on the front panel of the switch is
ON.
Caution:
Before powering on the switch, connect the ground wire.
The length of the DC power cord must be less than 3 m (9.8 ft.).
Chapter 3 Installing the Switch
Connector parts
Connector parts
Screw 1
Screw 1
Chassis
Chassis
3-14