Installing/Removing An Interface Module - HP HPE FlexFabric 5930 Installation Manual

Figure 34 Connecting the 650W DC power supply

Installing/Removing an interface module

CAUTION:
When you install or remove an interface module, follow these guidelines:
• Never touch the components on the interface module surface.
• Do not use excessive force.
The HPE 5930-2Slot+2QSFP+/HPE 5930-2Slot+2QSFP+ TAA switch provides two interface module
slots. The HPE 5930-4Slot/HPE 5930-4Slot TAA switch provides four interface module slots. For the
available interface modules, see
The interface module installation and removal procedures are the same. This section uses the
LSWM18QC interface module as an example.
Installing an interface module
Wear an ESD wrist strap and make sure the wrist strap makes good skin contact and is reliably
1.
grounded.
(Optional.) If the target interface module slot has a filler panel installed, remove the filler
2.
panel.
an example.
To remove a filler panel from an interface module slot:
a. Use your thumb and forefinger to hold the filler panel through the two holes.
b. Push right the metal tab in the left hole and pull out the filler panel along the guide rails.
Figure 35 Removing a filler panel from the interface module slot
Keep the removed filler panel secure for future use.
Unpack the interface module.
3.
"Appendix B FRUs and compatibility
Figure 35 uses the HPE 5930-2Slot+2QSFP+/HPE 5930-2Slot+2QSFP+ TAA switch as
28
matrixes."